When you think about options for heating your home, you may have already decided that it is time to install a heat pump. This may seem like a simple decision: Engage a plumber – get them to install a heat pump – job done! If only it was that simple. The truth is that the way you procure and install the heat pump can have a big influence on system performance, warranties and maintenance.

For those new to the heat pump industry an installer must have a number of credentials and accountabilities to be able to fit a heat pump. There must be a suitably qualified and experienced competent person to install the electrics and the plumbing, especially the hot water cylinder. There must be someone who designs the system in accordance with the manufacturers’ instructions and there must also be someone who makes sure that the installation complies with MCS design and MCS Installation guidance. MCS is the Microgeneration Certification Scheme and provides guidance and certification for Renewable technology manufacturers and Installers. If the homeowner wants any Government incentives then the installation must comply with MCS MIS guidance. The installation must be commissioned in accordance with the manufacturers instructions and also commissioned by an MCS registered company.

One person could theoretically do all of those things and hold all of those competencies but that is unlikely., and even if it was the case that one person would probably lack experience in some of the tasks. You could also have the other end of the scale where the ‘installer’ has none of the competencies and simply contracts them in. Usually it is something in between. Very often the actual installer, the person physically putting in the equipment,  pipework and wiring ,is not the lead designer. They have been told what to do and hopefully they do it.

Every route has a risk. My preferred route for new build is to actually engage the plumber and electrician on the job. This way if there are any leaks or blocks due to dirt in the system, or there is a mismatch in the electrical system, there is no blame game. The design is completed by either the manufacturer or the installation designer, The plumber and electrician are briefed and supported as to what needs to be fitted and where, and then the design team come back and commission the system in accordance with the design.

Of course, you can engage with a specialist installer who will provide and install the heat pump, they may also install the underfloor heating but may not include the radiators. It is important in this case to be absolutely clear who installs what and exactly where the handover points are so that you do not end up with underfloor heating downstairs, Radiators upstairs, a heat pump in the garden, but not pipes connecting them together. It does happen. The electrician must also be briefed as to what other works are being completed in the home as someone must sign off the completed installation and many trades do not like to sign off someone else's work, and especially without an inspection fee.

Defining your route is very important. Early engagement is vital. the whole team needs to be aware of the project requirements before agreeing the cost so that there are not financial surprises for variations and no finger pointing when things go wrong.